Edge Brass Elbow View larger

Edge Brass Elbow


New product

Edge Brass Elbow

More details

By buying this product you can collect up to 2 loyalty points. Your cart will total 2 points that can be converted into a voucher of $0.40.


Add to wishlist

Shipping Rates

Shipping Rates

Customer ratings and reviews

Nobody has posted a review yet
in this language

Rate / write a comment

More info

The installation of the brass elbow permits turbo boost pressures of greater than 20 psi without the waste gate opening.
  1. Using the 5/16” socket, loosen the two clamps securing the air induction hose to the air filter housing and the turbo inlet. Remove the hose and set it aside.
  2. Using the pliers, remove the crimp style clamp from the hose on the brass fitting located on the now exposed lower front side of the turbocharger. Remove the hose from the brass fitting and dispose of the crimp style clamp.
  3. Using the 7/16” wrench, unscrew the stock brass fitting out of the turbocharger housing. Using the 7/16” wrench, install the supplied brass fitting, tighten-be careful not to over-tighten. Slip the supplied hose clamp onto the stock hose, install the stock hose onto the supplied brass fitting and tighten the hose clamp with the ¼” socket. Reinstall the stock air hose onto the air filter housing and turbocharger inlet. Using the 5/16” socket, tighten both clamps securely.
  4. Using the 7/16 deep socket tighten all of the intercooler hose clamps on the air intake.
Final Inspection
Recheck all connections for a properly secure installation. Using the supplied wire ties, secure the wiring harness to prevent possible heat damage. Start the engine. The engine should start and idle like a stock truck. If the engine does not start or run properly, turn off the motor, remove the keys from the ignition, then check the Juice module connections, making sure all connectors are fastened tightly. If failure conditions still exist, contact your dealer or Edge Products, LLC.